Allied Telesis AT-IFS802SPOE Manuale Utente
86
AT-IFS802SP/POE(W)-80 User Manual
Spanning Tree Commands Set
Allied Telesis Commands Level
Description
Example
spanning-tree enable
G
Enable spanning tree
switch(config)#spanning-tree enable
spanning-tree priority
[0~61440]
G
Configure spanning tree
priority parameter
priority parameter
switch(config)#spanning-tree priority
32768
32768
spanning-tree max-age
[seconds]
G
Use the spanning-tree max-
age global configuration
command to change the
command to change the
interval between messages
the spanning tree receives
from the root switch. If a
from the root switch. If a
switch does not receive a
bridge protocol data unit
bridge protocol data unit
(BPDU) message from the
root switch within this
root switch within this
interval, it recomputed the
Spanning Tree Protocol
Spanning Tree Protocol
(STP) topology.
switch(config)#spanning-tree max-age 15
spanning-tree hello-
time
[seconds]
G
Use the spanning-tree hello-
time global configuration
command to specify the
command to specify the
interval between hello
bridge protocol data units
bridge protocol data units
(BPDUs).
switch(config)#spanning-tree hello-time 3
spanning-tree
forward-time
[seconds]
G
Use the spanning-tree
forward-time global
forward-time global
configuration command to
set the forwarding-time for
the specified spanning-tree
instances. The forwarding
time determines how long
instances. The forwarding
time determines how long
each of the listening and
learning states last before
the port begins forwarding.
the port begins forwarding.
switch(config)#spanning-tree forward-time
20
20
stp-path-cost
[1~200000000]
I
Use the spanning-tree cost
interface configuration
command to set the path
cost for Spanning Tree
command to set the path
cost for Spanning Tree
Protocol (STP) calculations.
In the event of a loop,
spanning tree considers the
path cost when selecting
In the event of a loop,
spanning tree considers the
path cost when selecting
an interface to place into
the forwarding state.
the forwarding state.
switch(config)#interface fastEthernet 2
switch(config-if)#stp-path-cost 20
switch(config-if)#stp-path-cost 20