Inter-Tel CS-5200 Manuale Utente

Page  222

Viewing System Speed Dial Numbers

System Speed Dial codes 000–999 can be stored in user-programmable endpoint buttons by
following the directions given on 

. These buttons allow one-button dialing of System

Speed Dial numbers.

The System Speed Dial numbers and names are stored in battery-backed RAM and will not be
erased in the event of a power failure.

The System Speed Dial numbers and names are programmed by the installer or at any Admin-
istrator endpoint. For programming instructions, refer to 

.

To view System Speed Dial numbers and names:.

  1.

While on-hook, press 

 or enter the System Speed Dial feature code (381). The

display shows REVIEW SYS SPEED # (000–999).

  2.

Enter the desired location code (000–999) or press the 

 menu button. The dis-

play shows the programmed name and number.

  3.

If desired, scroll forward through the Speed Dial locations in alphabetical order by
pressing the high end of the Volume button or the 

 button, or scroll backward by

pressing the low end of the Volume button or the 

 button.

  4.

Repeat steps 2 and 3 for each Speed Dial location to be viewed. Or, press 

 or 

 to terminate this feature.

  5.

To automatically select a trunk and dial the displayed number, press .

  1.

If desired, lift the handset and select an outgoing trunk. (You may skip this step.)

  2.

Press 

 or enter the System Speed Dial feature code (381). The display shows

REVIEW SYS SPEED # (000–999). Non-display endpoint users hear a confirmation
tone.

  3.

Enter the location code (000–999) for the desired number. If you have not selected a
trunk, press  

or 

the 

 menu button to accept the number and automatically

select a trunk. Or, press the ARS button, a trunk button, a trunk group button, or the

 button to select a trunk. The number is automatically dialed. Display end-

points show the number dialed unless it is a non-display number. If you hear reorder
tones, your endpoint is restricted from dialing the selected number. If the display shows
INVALID BIN NUMBER, you entered an invalid Speed Dial location code.

  1.

Lift the handset and select an outgoing trunk.

  2.

Hookflash and enter the System Speed Dial feature code (381). You hear a confirmation
tone.

  3.

Enter the location code (000–999) for the desired number. The number is automatically
dialed. If you hear reorder tones, your endpoint is restricted from dialing the selected
number.

If you make a mistake, use the 

 button to backspace.