Gateway 7450R Manuale Utente
Replacing and Adding Internal Devices
59
8
Remove the eight screws that secure the system board to the chassis, then
lift the system board out of the chassis.
lift the system board out of the chassis.
9
Remove the new system board from its anti-static bag and set any jumpers
that you may need to set for your configuration. See “System board” on
page 6 and “Setting the system board jumpers and switches” on page 64.
that you may need to set for your configuration. See “System board” on
page 6 and “Setting the system board jumpers and switches” on page 64.
10
Place the new system board in the chassis.
11
Replace the eight screws you removed in Step 8.
12
Install the DIMM(s) and processor(s) in the new system board. See
“Replacing memory” on page 32, “Replacing the primary processor” on
page 34, and “Replacing the secondary processor” on page 36.
“Replacing memory” on page 32, “Replacing the primary processor” on
page 34, and “Replacing the secondary processor” on page 36.
13
Reconnect the system cables to the appropriate connectors on the system
board. See “System board” on page 6 for reference.
board. See “System board” on page 6 for reference.
14
Replace the riser card using the two screws you removed in Step 4. Make
sure you seat the riser card connector securely onto the edge connector
on the system board.
sure you seat the riser card connector securely onto the edge connector
on the system board.
8507328.book Page 59 Thursday, February 15, 2001 11:28 AM