Fujitsu RX600 S5 Manuale Utente
RX600 S5
Operating Manual
105
CSS components
Hot-plug components
Figure 26: Installing the 2.5-inch HDD module
Ê
Carefully push the HDD module into the empty slot (1) until it stops.
Ê
Push the handle completely (2) in the direction of the arrow until the locking
mechanism engages.
mechanism engages.
8.1.3.4
Removing the HDD module
V
CAUTION!
●
Only remove an HDD module during operation if the drive is not
currently being accessed. Observe the control LEDs for the
corresponding HDD modules (see
currently being accessed. Observe the control LEDs for the
corresponding HDD modules (see
).
●
Under no circumstances should you remove an HDD module while
the system is in operation if you are not sure that the hard disk drive
is operated by a RAID controller and belongs to a disk array that is
operating in RAID level 1, 1E, 10, 5, 50, 6 or 60.
the system is in operation if you are not sure that the hard disk drive
is operated by a RAID controller and belongs to a disk array that is
operating in RAID level 1, 1E, 10, 5, 50, 6 or 60.
An HDD module can only be replaced during operation in conjunction
with a corresponding RAID configuration.
with a corresponding RAID configuration.
●
All HDD modules (drives) must be uniquely identified so that they can
be reinstalled in their original mounting locations later. If this is not
done, existing data can be lost.
be reinstalled in their original mounting locations later. If this is not
done, existing data can be lost.
If you want to remove an HDD module during operation, proceed as follows:
/
/
0