Fujitsu RX200 S2 Manuale Utente
107
PRIMERGY RX200 S2 User’s Guide
3
O
S
In
st
allation
U
sing ServerS
ta
rt
3
Insert the ServerStart floppy disk copied in the preparatory procedure into the
floppy disk drive and click [Start here to configuration file].
The [Open ServerStart Configuration File] window appears.
4
Specify "SerStartBatch.ini" on drive A and click [Create].
The display returns to the preconfiguration mode window.
For procedures from setting wizards to completion of installation, refer to "3.2 Preconfiguration
When performing remote installation, refer to "3.4 Remote Installation" (
Settings values in wizards
Setting items in wizards are set to the values set on the first server. For installation on subse-
quent servers, you must change the following items in the "OS installation wizard". For other
items, change the settings as necessary. You do not need to start up wizards where no settings
will be changed.
quent servers, you must change the following items in the "OS installation wizard". For other
items, change the settings as necessary. You do not need to start up wizards where no settings
will be changed.
If the settings for the first server are not reflected to wizards, perform the procedures from
copying the floppy disk over again.
copying the floppy disk over again.
table: Settings to be Changed for Installation on Subsequent Servers
Window
name
Setting item name
Remarks
User
Information
Information
Computer name
The setting must be changed when the second
and subsequent servers are on the same
network as the first server.
and subsequent servers are on the same
network as the first server.
Product ID/CD key
The setting must be changed.
Network
Protocol
Protocol
IP address
The setting must be changed when the second
and subsequent servers are on the same
network as the first server.
and subsequent servers are on the same
network as the first server.