Cisco Systems Servers Manuale Utente

 The Juniper RADIUS parameters appear only if all the following are true:

A AAA client has been configured to use RADIUS (Juniper) in Network 
Configuration.

The Per-user TACACS+/RADIUS Attributes check box is selected under 
Advanced Options in the Interface Configuration section.

User-level RADIUS (Juniper) attributes you intend to apply have been 
enabled under RADIUS (Juniper) in the Interface Configuration section.

Juniper RADIUS represents only the Juniper proprietary attributes. You must 
configure both the IETF RADIUS and Juniper RADIUS attributes. Proprietary 
attributes override IETF attributes.

To hide or display Juniper RADIUS attributes, see the 

To configure and enable Juniper RADIUS attributes to be applied as an 
authorization for the current user, follow these steps:

Perform Steps 1 through 3 of the 

Result: The User Setup Edit page opens. The username being added or edited 
appears at the top of the page.

Before configuring Juniper RADIUS attributes, be sure your IETF RADIUS 
attributes are configured properly. For more information about setting IETF 
RADIUS attributes, see the 

In the Juniper RADIUS Attributes table, to specify the attributes that should be 
authorized for the user, follow these steps:

Select the check box next to the particular attribute.

Further define the authorization for that attribute in the box next to it.

Continue to select and define attributes, as applicable.

For more information about attributes, see 

 or your AAA client documentation.