Honeywell 3800gPDF Manuale Utente

11 - 4

You can activate and deactivate the imager with serial trigger commands.  First, 
the imager must be put in Manual/Serial Trigger Mode either by scanning the 
Manual/Serial Trigger Mode bar code (

), or by sending the Manual/

Serial Menu Command (

).  Once the imager is in serial trigger mode, 

the trigger is activated and deactivated by sending the following commands:

Activate:SYN T CR

Deactivate:SYN U CR

The imager scans until a bar code has been read, until the deactivate command 
is sent, or until the serial time-out has been reached (see 

page 3-3 for a description, and the serial command on 

If you aren’t sure what programming options are in your imager, or you’ve 
changed some options and want the factory settings restored, scan the 

dard Product Default Settings bar code below.

The chart on the following pages lists the factory default settings for each of the 
menu commands (indicated by an asterisk (*) on the programming pages).

Standard Product Default Settings