Sharp AR-M257 Manuale Utente

Use this program to enable stream feeding mode.
When this mode is enabled and originals are scanned 
from the REVERSING SINGLE PASS FEEDER, an 
original can be added to the REVERSING SINGLE 
PASS FEEDER within 5 seconds after the previous 
original is fed, and be automatically scanned using the 
settings of the previous original. This function can be 
used with the copy function and the scanner function.
This program is initially disabled (factory default 
setting).

This program is used to change the language used in 
the display.
The factory default setting is "AMERICAN ENGLISH".

When this program is disabled, the display will close 
the screen that is currently open and return to the 
initial screen if no keys are touched for 60 seconds. 
When the program is enabled, the display will not 
close the screen that is currently open.
This program is initially disabled (factory default 
setting).

This program can be enabled to prohibit changes to 
the paper tray settings in the user settings.
Note that bypass tray settings will still be possible.
This program is initially disabled (factory default 
setting).

This program can be enabled to prohibit adjustment of 
the "CLOCK" setting in the custom settings.
This program is initially disabled (factory default 
setting).

 

Use these programs when a peripheral device on the 
machine has failed or when you wish to temporarily 
disable a device. The programs can also be used to 
change the function setting of a device as required by 
your conditions of use.
"DEVICE CONTROL" consists of the following 
programs:

● DISABLING OF DOCUMENT FEEDER

● DISABLING OF DUPLEX

● DISABLING OF STAPLER

● OUTPUT TRAYS

● OFFSET FUNCTION SETTING

● MEMORY FOR PRINTER

● DISABLING OF CENTER TRAY COUNTING

● RETURN FROM COPY MODE TIMING

● MIX SIZE ORIGINAL FEEDING MODE

● SECURITY SETTINGS

Use this program when the RSPF is not operational or 
you wish to disable the automatic feeding function. 
(Originals can still be scanned using the document 
glass.)
This program is initially disabled (factory default 
setting).

Use this program when you wish to disable the 
two-sided printing function or the function has failed.
When this program is enabled, only one-sided printing 
is possible.This program is initially disabled (factory 
default setting).

Use this program to disable stapling.
When this program is enabled, stapling does not take 
place.This program is initially disabled (factory default 
setting).

KEY OPERATOR PROGRAMS

DEVICE CONTROL

DISABLING OF DUPLEX

DISABLING OF STAPLER

DISABLING OF DOCUMENT
FEEDER

OK

1/3

AR-M237_keyope_SEC.book  12 ページ  ２００６年１１月２０日　月曜日　午後６時３１分