PSC 1400I Manuale Utente

Global Pre-

fix/Suffix

START / END

PROGRAMMING BARCODES

Sets up to 20 characters each from the set of ASCII characters or any hex value from 0 to FF. To configure this feature, scan the 
“START/END” bar code above to place the unit in Programming Mode, then the “Set Prefix” or “Set Suffix,” followed by the digits from 
the Alphanumeric table in 

 representing your desired character(s). Reference the section, 

, for more information. Exit programming mode by scanning the “START/END” barcode again (scan 

“START/END” twice if less than 20 characters have been selected).

Set Prefix

Set Suffix