NEC 5800/180Ra-7 Manuale Utente
Setting Up the System 2-7
Attaching the Center Slide Bar to the BSU
Using the two center slide bars removed in the previous procedure attach them
to the BSU as follows:
to the BSU as follows:
1. Align the mounting holes in each slide bar to the threaded holes on the side
of the BSU (see Figure 2-3).
Note:
The holes in the two center slide bars line up only
one way with the holes in the BSU.
2. Secure each slide bar to the BSU using four screws, as shown in Figure 2-3
A – Center Slide Bar
B – Safety Latch
C – Screws (1 of 4)
D – Threaded Holes in BSU
B – Safety Latch
C – Screws (1 of 4)
D – Threaded Holes in BSU
Figure 2-3. Attaching the Inner Component Slide Bar to the BSU
Installing the Rack Mounting Bracket Assemblies into the Rack Cabinet
Before you can mount the BSU in the rack cabinet, you must install the Rack
Mounting Bracket Assemblies in the rack cabinet.
Mounting Bracket Assemblies in the rack cabinet.
Note:
You must use the following procedure to prepare
the rack cabinet before mounting the BSU into it. Observe all
safety precautions, warnings, and cautions noted throughout
this chapter.
safety precautions, warnings, and cautions noted throughout
this chapter.
Use the following procedure to install the Rack Mounting Bracket Assemblies
into the rack cabinet.
into the rack cabinet.
1. Determine where you want to install the BSU in the rack cabinet.