Omega CNiS16 Manuale Utente

Press 

a

1) Press 

a, if necessary, until CNFG prompt appears.

Press 

d

2) Display advances to 

INPT Input Menu.

Press 

d

3) Display flashes 

0-0.1, 0-1.0, 0-10 or 0-20 (0 to 100 mV, 

0 to 1 V, 0 to 10 V or 0 to 20 mA).

Press 

b

4) Scroll through the available selection of input ranges 

0-0.1,

0-1.0, 0-10 or 0-20 to the selection of your choice.

Press 

d

5) Display shows 

STRD stored message momentarily and then

advances to the 

RT1B Ratiometric Operation Submenu.

100 mV 1 V

10 V

0 – 20 mA

0-0.1

0-1.0

0-10

0-20

Press 

d

6) Display flashes previous selection of 

ENBL Enable or DSBL

Disable.

Press 

b

7) Scroll through the available selection 

ENBL or DSBL

(flashing).

Press 

d

8) Display shows 

STRD stored message momentarily and then

advances to 

RESO Input/Reading Resolution Submenu.

The Ratiometric operations are typically used for Strain gauge controller.
If your controller is configured as Process (Voltage and Current), set
RTIB to DSBL disable Ratiometric operations.

If 

ENBL Ratiometric operations Enabled was selected, the changes to

the excitation voltage will be compensated through Ratio measurement. 
If 

DSBL Ratiometric operation Disabled was selected, any changes to

the excitation voltage will effect the output of strain gauge bridge and, as
a result, a reading of the controller. 

Press 

a

9) Display flashes previous selection of 

LO Low or HI High

resolution.

Press 

d

10) Scroll through the available selection 

LO or HI (flashing).

Press 

d

11) Display shows 

STRD stored message momentarily and then

advances to 

BUTN Button Selection Submenu.

If 

LO Low Resolution was selected the resolution of the display is 10 µV.

If 

HI High Resolution was selected the resolution of the display is 1 µV.

In case of High Resolution, the maximum input signal is 10 mV.

18