Grizzly T21319 Dépliant

Introduction

The Model T21319 24" Bending Brake is ideal for
a small workshop environment where ease of use
is important. The Model T21319 can bend up to 18
gauge (0.473 in. or 12mm) mild steel.

Figure 1. Model T21319 24" Bending Brake.

WarnIng: no portIon oF thIs manual may be reproduced In any shape

or Form WIthout the WrItten approval oF grIzzly IndustrIal, Inc.

#JB11595 prinTed in ChinA

Inventory

(Figure 2)

a. Bending Brake Assembly ........................... 1

b. Clamping Angle .......................................... 1

c. Clamp Assemblies ...................................... 2

d. Breaker Bar levers ..................................... 2

e. hardware Bag (not shown)

— hex Bolts M10-1.25 x 30 ........................ 4

— hex nuts M10 ........................................ 4

— lock Washers 10mm ............................. 4

assembly

to assemble your bending brake:

1. securely mount the bending brake assembly

to a workbench or other stable surface using
8mm hex bolts, flat washers, lock washers
and hex nuts. Mounting hole locations are
indicated in

Figure 3.

2. place the clamping angle on the bending

brake assembly.

3. Mount each clamp assembly as shown in

Figure 4 on the next page. ensure that each
adjustment set screw shown in

Figure 4 is

towards the outside of the bending brake
assembly. secure with hex bolts, lock wash-
ers and hex nuts.

Figure 2. inventory.

Figure 3. Mounting hole locations (right side of

bending brake not shown).

model t21319

24" bendIng braKe

InstructIon sheet