Grizzly G0563 Manuale Utente

Model G0563/G0564 (Mfd. Since 10/11)

-27-

Fence

The Model G0563/G0564 comes with a remov-
able fence to assist sanding operations when
table is in the horizontal position.

Components and Hardware Needed:

Qty

Fence ................................................................. 1
Star Knob .......................................................... 2
Flat Washer

" ................................................ 2

To mount fence:

1. Set fence on table and align the slots with the

threaded holes in table.

2. Thread the star knobs and flat washers into

the threaded table holes (

Figure 25) and

tighten.

Figure 25. Fence installed.

Edge & End Sanding

Proper use of the oscillating edge sander will yield
excellent sanding results due to the oscillating
movement.

If you must feed a workpiece into the sand-

ing belt corner first, feed the trailing cor-

ner first. Feeding the leading corner first

could cause the sanding belt to grab the

workpiece and jerk it out of your hands.

Figure 24. Typical edge sanding operation.

3. When you have completed your sanding

operation, turn power sander

OFF.

To perform an edge or end sanding operation:

1. Start sander by turning sander ON.

2. Support the workpiece against the back stop,

and slowly feed workpiece into moving belt,
as shown in

Figure 24.