Grizzly H6246 Guida Utente
-8-
H6246 Meat Cutting Bandsaw
Figure 2. A 5-15 plug and receptacle.
Serious personal injury could occur if you
connect the machine to the power source
before you have completed the set up pro-
cess. DO NOT connect the machine to the
power source until instructed to do so.
110V Operation
Amperage Draw
The
3
/
4
HP motor on the Model H6246 will draw
the following amps:
Motor Load ..............................................5 Amps
Circuit Breaker Requirements
Install your machine on a dedicated circuit to
reduce the possibility of tripping the circuit break-
er. If the circuit breaker frequently trips, have the
circuit inspected by a qualified electrician. Never
use a larger circuit breaker than stated below, or
you will increase the risk of fire.
reduce the possibility of tripping the circuit break-
er. If the circuit breaker frequently trips, have the
circuit inspected by a qualified electrician. Never
use a larger circuit breaker than stated below, or
you will increase the risk of fire.
Circuit Breaker .........................................10 Amp
Plug Type
The Model H6246 is supplied with a 5-15 plug,
similar to
similar to
Figure 2.
This machine must have a ground prong in
the plug to help ensure that it is grounded.
DO NOT remove ground prong from plug
to fit into a two-pronged outlet! If the plug
will not fit the outlet, have the proper outlet
installed by a qualified electrician.
Extension Cords
•
Make sure the cord is rated Standard Service
(grade S) or better.
(grade S) or better.
•
The extension cord must contain a ground
wire and plug pin.
wire and plug pin.
•
Use at least a 16 gauge cord. Use a 14 gauge
cord if the cord is between 51-100 feet.
cord if the cord is between 51-100 feet.
SECTION 2: CIRCUIT REQUIREMENTS
Electrocution or fire could
result if this machine is
not grounded correctly or
if your electrical configu-
ration does not comply
with local and state codes.
Ensure compliance by
checking with a qualified
electrician!