Grizzly G1019Z Manuale Utente
-14-
Model G1019Z 14" Bandsaw
6.
Secure the table to the support bracket by
securing the two trunnion knobs onto the
trunnion bolts. Remember to position the
table so that the miter slot is to the right of
the blade as you face the front of the band-
saw.
securing the two trunnion knobs onto the
trunnion bolts. Remember to position the
table so that the miter slot is to the right of
the blade as you face the front of the band-
saw.
See Figure 10.
Figure 9.
Stop bolt assembled on bracket.
Figure 10.
Positioning table on support bracket.
7.
Place the table insert in the table top and
place the tapered pin so it fits snugly in the
hole on the side of the table. Do not use
excessive force.
place the tapered pin so it fits snugly in the
hole on the side of the table. Do not use
excessive force.
NOTICE
The tapered table pin must be in position in
the table when operating the bandsaw. This
maintains the table surface flush with no edge
for the workpiece to catch on.
the table when operating the bandsaw. This
maintains the table surface flush with no edge
for the workpiece to catch on.
Table and Table
Support Bracket
The bandsaw table secures to the table trunnions.
The trunnions mount to the table support bracket
and the table support bracket mounts to the band-
saw unit. The trunnions are premounted to the
table. To mount the bandsaw table:
The trunnions mount to the table support bracket
and the table support bracket mounts to the band-
saw unit. The trunnions are premounted to the
table. To mount the bandsaw table:
1.
Remove the two table support bracket
mounting bolts from the bandsaw body.
mounting bolts from the bandsaw body.
2.
Insert the alignment pin that positions the
table support bracket to the bandsaw body.
Place the table bracket on the body over the
alignment pin and secure it to the bandsaw
with the two bolts.
table support bracket to the bandsaw body.
Place the table bracket on the body over the
alignment pin and secure it to the bandsaw
with the two bolts.
See Figure 8.
Figure 8.
Aligning bracket on the pins.
3.
Thread the locknut onto the table stop bolt
and thread the bolt into the table support
bracket.
and thread the bolt into the table support
bracket.
See Figure 9.
Bolt adjustments are
covered in the “Table Adjustments” section
beginning on page 18.
beginning on page 18.
4.
Remove tapered pin from the table.
5.
Slip the table past the blade through the
table slot, rotate the table 90°, and set the
table trunnions onto the bracket. Make sure
the trunnion bolts drop through the support
bracket.
table slot, rotate the table 90°, and set the
table trunnions onto the bracket. Make sure
the trunnion bolts drop through the support
bracket.