Grizzly G1019Z Manuale Utente

-22-

Model G1019Z 14" Bandsaw

Fence operation is controlled by the threaded
knob located on the front of the fence. The knob,
when screwed tight, locks the fence to the front
rail. To change the fence position, loosen the
knob and slide the fence along the rail. Use a tape
measure or ruler to position the fence from the
blade.

Loosen the motor mounting bolts and move the
motor accordingly to slacken the V-Belt. It should
now be easy to move the belt onto the pulleys of
choice. Adjust belt tension and check the align-
ment according to the instructions in the
Adjustments Section. Refer to 

to deter-

mine which pulley pair is required for the desired
blade speed.

Selecting pulleys for desired blade speed.

Once assembly is complete, adjustments are
done to your satisfaction and tools are safely put
away, you are ready to test run the machine.

Turn on the power supply at the main panel.
Press the switch in the START position. Make
sure that your finger is poised on the switch to
press in the STOP position, just in case there’s a
problem. The bandsaw should run smoothly, with
little or no vibration or rubbing noises. Strange or
unnatural noises should be investigated and cor-
rected before operating the machine further. 

If you cannot easily locate the source of an
unusual noise or vibration, contact our Service
Department for help.