Grizzly G1012 Manuale Utente

G1012 18" Bandsaw

-13-

Mount the motor onto the motor bracket.
Secure with (4) 

5

⁄

16

" -18 x 

3

⁄

4

" hex head bolts,

washers and nuts. Hand-tighten for now.

Place the smallest key in the groove on the
motor shaft. Line up the key on the shaft with
the pulley keyway. Slide the motor pulley
(the small triple-grooved pulley) onto the
motor shaft. Insert one of the small 

1

⁄

4

"-20 x

1

⁄

4

" setscrews in the bottom of the middle pul-

ley groove and tighten with the included
3mm hex wrench as shown in 

Figure 6.

Attach the four legs to the top of the stand
using the 

5

/

16

"-18 x 

1

/

2

" carriage bolts, wash-

ers and nuts provided. Do not tighten down
bolts completely at this time.

Figure 5. Motor bracket attached to stand top.

Figure 6. Securing motor pulley to motor shaft.

Figure 7. Legs, braces, and one stand side

attached to stand

Figure 8. Legs, braces, and both stand sides

assembled as an option.

Attach the two horizontal braces to the legs
and secure with the 

5

/

16

"-18 x 

1

/

2

" carriage

bolts, washers and nuts provided. Attach
one of the stand sides on the opposite side
of the pulley slot in the stand top. Your
assembly should now look like 

Figure 7.