Grizzly G1012 Manuale Utente

G1012 18" Bandsaw

-17-

To tighten the belt from the stepped pulley to
the motor, loosen the nuts on each motor
adjustment bolt and lower the motor into
position. The weight of the motor is sufficient
for the amount of tension required. Tighten
the nuts against the motor plate, so your
assembly looks similar to 

Figure 17.

Figure 18. Belt cover mounted to stand.

Figure 17. V-belts mounted on pulleys.

When all belts are installed, aligned, and
tightened, fasten the last stand side to the
stand legs. (If this has already been done,
skip this step.)

Place the belt cover over the pulleys on the
bandsaw unit and secure with the (2) 

1

⁄

4

"-20

x

1

⁄

2

" hex bolts, (4) 

1

⁄

4

" washers, and (2) 

1

⁄

4

"-

20 hex nuts. Your assembly should now look
similar to 

Figure 18.