Grizzly G0664 Manuale Utente
-26-
g0664 heavy duty Metal-Cutting Bandsaw
figure 25. 0° stop bracket.
3. locate the 0° stop bracket and swivel it out
of the way, as shown in
figure 25. this will
allow the bow to rotate past 0°.
4. loosen the vise position lock lever and slide
the vise assembly to the right side of the saw
table (
table (
figure 26).
5. rotate the saw bow to the desired angle, as
indicated by the scale, then re-tighten the
swivel lock lever. Make sure the vise is clear
of the path of the saw before proceeding.
swivel lock lever. Make sure the vise is clear
of the path of the saw before proceeding.
figure 26. positioning Vise.
0° stop Bracket
Vise position lock lever
Cutting Angle
your bandsaw has a locking turret with a range of
-45° to 60°.
-45° to 60°.
To set the cutting angle between 0° and 60°:
1. raise the bow high enough to clear the vise
and press the emergency stop button to pre-
vent accidental startup.
vent accidental startup.
2. loosen the saw angle lock lever, rotate the
saw bow to the desired angle, as indicated by
the scale, then re-tighten the swivel lock lever
(
the scale, then re-tighten the swivel lock lever
(
figure 24).
figure 24. saw angle lock lever.
scale
To set the cutting angle between 0° and -45°:
1. raise the bow high enough to clear the vise
and press the emergency stop button to pre-
vent accidental startup.
vent accidental startup.
2. loosen the saw angle lock lever, and rotate
the bow to approximately 45°.
saw angle lock lever