Grizzly G0503 Manuale Utente

Model g0503 (Mfg. since 12/08)

-45-

figure 62. Checking table alignment.

4. to raise the left side, loosen the lock nuts

on the conveyor adjustment bolts on the left
side and tighten the adjustment bolts. do
the same procedure to the right side bolts to
raise the right side.

5. tighten the lock nuts on the adjustment bolts

and tighten the conveyor mounting bolts.

6. Connect the resaw to the power, and repeat

steps 1 and 2.

—if the measurements are close to correct,

but need fine tuning, continue to

step 6.

—if large adjustments are necessary, repeat

steps 3 and 4.

7. loosen the cap screw shown in figure 61.

3. place a square against the surface of the

wheel and slide it up against the bars on the
conveyor table.

— if the square touches both bars, no adjust-

ment is necessary.

— if the square touches the front bar, but

not the back bar, the front of the conveyor
needs to be raised. go to

step 4.

— if the square touches the back bar, but

not the front bar, the back of the conveyor
needs to be raised. go to

step 4.

4. loosen all six of the conveyor mounting

bolts.

5. to adjust the tilt, loosen the lock nuts on the

conveyor  adjustment  bolts  on  the  end  that
needs  to  be  raised  and  tighten  the  adjust-
ment  bolts  until  the  square  touches  both
bars.

6. tighten the lock nuts on the adjustment bolts

and tighten the conveyor mounting bolts.

To adjust the conveyor table front to back:

1. Disconnect the resaw from the power

source!

2. place two flat bars of wood or metal under

the conveyer belt as shown in

figure 62.

figure 61. Conveyor fine adjustment.

8. the adjusting nut shown in figure 61 raises,

or lowers, the non-drive side of the bandsaw
blade (the side opposite the motor). insert the
pry tool into the adjusting nut.

—rotate the adjusting nut to the right to raise

the bandsaw blade.

—rotate the adjusting nut to the left to lower

the bandsaw blade.

9. retighten the cap screws, connect the resaw

to the power, and repeat