IBM Type 8677 Manuale Utente
Completing the installation
After you connect the cables to the modules and route the cables (if necessary, see
the Rack Installation Instructions for information about routing the cables), start the
BladeCenter unit (if it is not already started), and verify that it is working properly,
as follows:
the Rack Installation Instructions for information about routing the cables), start the
BladeCenter unit (if it is not already started), and verify that it is working properly,
as follows:
1. Start the BladeCenter unit by connecting the power-module power cords to a
220-volt power source (a 220-volt power distribution unit (PDU) that is
connected to a 220-volt ac power outlet or directly to a 220-volt ac power
outlet).
connected to a 220-volt ac power outlet or directly to a 220-volt ac power
outlet).
2. Make sure the LEDs on the modules indicate that they are operating properly.
Verify that:
v
The dc power LED and the ac power LED on each power module are lit and
that the power module error LED (2320-watt power modules only) on each
power module is not lit.
that the power module error LED (2320-watt power modules only) on each
power module is not lit.
v
The OK LED on each management module is lit.
v
The OK LED on each I/O module is lit.
3. Make sure the Power-on LED on each blade server is lit, either steady or
blinking.
See “BladeCenter unit power, controls, and indicators” on page 11 for information
about starting the BladeCenter unit and the location of the LEDs on the modules.
See the Installation and User’s Guide for your blade server for the location of the
LEDs on the blade servers.
about starting the BladeCenter unit and the location of the LEDs on the modules.
See the Installation and User’s Guide for your blade server for the location of the
LEDs on the blade servers.
Input/output connectors
Your BladeCenter has one Universal Serial Bus (USB) version 1.1 or 2.0 connector,
depending on BladeCenter unit type, on the front of the BladeCenter unit. All other
input/output connectors are provided by devices installed in the BladeCenter unit,
such as management modules or I/O modules. See the documentation for these
devices for information about the input/output connectors and their function.
depending on BladeCenter unit type, on the front of the BladeCenter unit. All other
input/output connectors are provided by devices installed in the BladeCenter unit,
such as management modules or I/O modules. See the documentation for these
devices for information about the input/output connectors and their function.
Use the USB connector to connect a USB device other than a mouse or keyboard
to the BladeCenter unit. Using Plug and Play technology, USB devices are
configured automatically.
to the BladeCenter unit. Using Plug and Play technology, USB devices are
configured automatically.
The following illustration shows a USB connector.
1
4
Use a USB cable to connect a device to a USB connector. If you need to connect
more USB devices than the BladeCenter unit has USB connectors, use a USB hub
to connect additional devices.
more USB devices than the BladeCenter unit has USB connectors, use a USB hub
to connect additional devices.
If you connect a USB keyboard that has a mouse port, the keyboard emulates a
mouse, and you cannot disable the mouse settings in the blade server
Configuration/Setup Utility program.
mouse, and you cannot disable the mouse settings in the blade server
Configuration/Setup Utility program.
46
BladeCenter E Type 8677 and 1881: Hardware Maintenance Manual and Troubleshooting Guide