IBM Type 8677 Manuale Utente
Tabs
Slots
Lift points
Pressure points
Reverse these instructions to reinstall the media tray cover. Press the rear of the
cover down onto the two fasteners to secure the cover in place.
cover down onto the two fasteners to secure the cover in place.
Optical or diskette drive
Note: The diskette drive is not present in all BladeCenter unit models.
The optical drive and the diskette drive have the same securing mechanism, a
wire-retention spring. On the optical drive, the wire spring is on the left; on the
diskette drive, the wire spring is on the right.
wire-retention spring. On the optical drive, the wire spring is on the left; on the
diskette drive, the wire spring is on the right.
Complete the following steps to replace the optical drive or the diskette drive.
Note:
v
v
Read the safety notices at “Safety information” on page 87.
v
1. Remove the media tray (see “Media tray” on page 48).
2. Remove the media-tray cover (see “Removing the media-tray cover” on page
CD-ROM drive
Diskette drive
Drive guide
Drive guide
Drive guide
Drive guide
Wire spring
Wire spring
Retention hook
Retention hook
Chapter 5. Service replaceable units
49