KUHN RIKON 10-110B/E Manuale Utente

12

1. Locate the locking pin with the black handle and 
thread it through the sliding table body with wrench 
as shown. Figure 17.

NOTE:
The sliding table should be set approximately 3/64” 
of an inch higher than the saw table to prevent 
sheet goods from binding against the table. 

1. Loosen the two sliding table lock knobs slightly. 
(B, Fig. 18)
2. Adjust the set screws acordingly which will place 
pressure against the pressure plate (A, Fig. 18)
3. Tighten the sliding table lock knobs and check 
adjustment. Repeat if necessary.

1. Loosen the lower adjusting nuts on the carriage 
table support arm (A, Fig. 19). 
2. Raise or lower the upper adjusting nuts until the 
sliding table carriage is level (B, Fig. 19).
3. Tighten the lower adjusting nuts and check table 
for level. Repeat if necessary.

After the adjustments above are completed it may 
be necessary to check for parallel, especially if the 
sliding table scrubs the saw table.

To align for parallel please repeat the steps 
described above. If further adjustment is needed, 
loosen the 8MM hex head bolts that hold the cast 
mounting bracket to the body of the saw. (A,Fig 20)

A

B