KUHN RIKON 10-110B/E Manuale Utente

8

1. Open the motor cover located at the left side of 
the saw.
2. With assistance hold the swing arm bracket 
against the saw body and attach using four 8MM 
hex bolts, four 8MM washers and four 8MM hex 
nuts. 
3. Slide the four 8MM hex bolts through the bracket 
and saw body and attach using the four 8 washers 
and four 8MM hex nuts from inside the saw body. 
Figure 1.

1.  Slide the swing arm extenstion bar through the 
swing arm bracket making sure that the large hole 
is installed fi rst and that the set screw is pointing 
downward. Figure 2.

1. Locate the sliding table mounting hardware 
which includes two knobs, two T-nuts, two 8MM 
washers and two adjusting plates. Figure 3.

2. Assemble the hardware as shown (Fig. 3) and 
slide the T-nut into the track (Fig. 4) making sure 
that the clamp plate is against the bottom of the 
table assembly.