Graco Inc. 288046 Manuale Utente

7.

Turn off the solvent supply.

8.

Perform Pressure Relief Procedure, page 12.

9.

Disconnect the solvent supply hose from the gun.

10. Dip the end of a soft-bristle brush into a compatible 

solvent. Do not continuously soak the brush's bris-
tles with solvent and do not use a wire brush.

11. With the gun pointed down, clean the front of the 

gun, using the soft-bristle brush and solvent.

12. Scrub the air cap retaining ring (8), air cap (30), and 

spray tip (9) with the soft-bristle brush. To clean out 
air cap holes, use a soft tool, such as a toothpick, to 
avoid damaging critical surfaces. Blow air through 
the spray tip to ensure the orifice is clean. Clean the 
air cap and spray tip daily, minimum. Some applica-
tions require more frequent cleaning.

13. Install the air cap retaining ring (8), air cap (30), and 

spray tip (9).

14. Dampen a soft cloth with solvent and wring-out the 

excess. Point the gun down and wipe off the outside 
of the gun.

TI4845A

TI6570A