Graco Inc. 309225W Manuale Utente

This sprayer is set up for most airless spraying 
applications. Details on tip selection, tip wear, 
coat thickness, etc. are provided on page 13.

•

Spray should be atomized (evenly distrib-
uted, no gaps at edges). Start at low pres-
sure setting, increase pressure a little at a 
time until you see a good spray pattern, 
without tails.

•

Spray at lowest pressure that atomizes 
paint.

•

If maximum sprayer pressure is not enough 
for a good spray pattern, tip is too worn. 
See Reversible Spray Tip Selection Chart, 
page 14.

Align arrow on sprayer with function symbol on 
Pressure Control knob, page 11.

•

Turning knob to right (clockwise) 
increases pressure at gun. 

•

Turning it left (counter-clockwise) 
decreases pressure.

•

Hold gun 12 
in. (30 cm) 
from surface 
and aim 
straight at 
surface. Tilt-
ing gun to 
direct spray 
angle causes 
an uneven 
finish.

•

Flex wrist to 
keep gun 
pointed 
straight. Fan-
ning gun to 
direct spray at 
angle causes 
uneven finish.

Motor only runs when gun is triggered. 
Sprayer is designed to stop pumping when 
gun trigger is released.

If tails persist when spraying at the highest 
pressure, a larger tip is needed or the 
material may need to be thinned.

GOOD
SPRAY

TAILS

PRESSURE
TOO

TIA

Practice spraying on a piece of scrap or 
cardboard before you begin spraying.

TIA

even finish

thick

thin

uneven

finish

TIA

even finish

thin

thick

thin