Grizzly G0763 Manuale Utente
-18-
Model G0763 (Mfg. Since 8/13)
Assembly
For accurate results and to prevent warping
the cast iron ways, the table MUST be level
from side to side and from front to back.
Recheck the ways 24 hours after installation,
two weeks after that, and then annually to
make sure they remain level.
10. With help from another person to steady the
load, lift machine enough to remove pallet.
11. With machine still suspended above floor,
thread leveling pad bolts, as illustrated in
Figure 14, into holes used to bolt machine to
pallet.
pallet.
Note: Make sure flat washer and hex nut
are above machine base and bottom of bolt
extends approximately
are above machine base and bottom of bolt
extends approximately
3
⁄
4
" below machine
base.
Leveling
Pad
Threaded
Hole
Flat Washer
& Nut Above
Machine Base
Approx.
3
⁄
4
"
Figure 14. Leveling pad and bolt installed.
13. Using a precision level on unpainted table
surface without magnetic chuck, adjust level-
ing pad bolts until table is level from side to
side and front to back.
ing pad bolts until table is level from side to
side and front to back.
14. When table is properly leveled, tighten down
hex nuts on bolts to secure settings.
15. Reconnect coolant pump electrical cord and
coolant hose.
To assemble the surface grinder:
1. Install handles on X- and Z-axis handwheels.
2. Remove table restraints.
Take care not to damage table or saddle
ways. Any damage to these surfaces will be
permanent and result in poor finishes.
3. With help from another person, remove table
and place it upside down on a clean, flat sur-
face.
face.
4. Store plastic shipping rods (see Figure 15) for
future use when storing or moving machine to
protect ways.
protect ways.
5. Clean the table and saddle ways, and
table ball bearing segments, as directed on
Page 15.
12. Position leveling pads underneath bolts and
lower machine so the bolts rest in center of
pads.
pads.
Figure 15. Plastic rods used for shipping or
storage purposes.
Rods