Grizzly G0454 Manuale Utente
-26-
g0453/g0454 (Mfg. since 3/08)
Bed Roller height
Bed roller height range ..............0.002"–0.020"
the correct height of the bed rollers will vary,
depending on the type of material you intend to
plane. however, as a general rule, keep the bed
roller height within 0.002"–0.020" above the table
surface, as illustrated in
depending on the type of material you intend to
plane. however, as a general rule, keep the bed
roller height within 0.002"–0.020" above the table
surface, as illustrated in
figure 18.
When planing rough stock, set the rollers high
to keep the lumber from dragging along the bed.
When planing milled lumber, set the rollers low to
help minimize snipe.
to keep the lumber from dragging along the bed.
When planing milled lumber, set the rollers low to
help minimize snipe.
to ensure accurate results and make the adjust-
ment process quicker and easier, we recommend
using a rotacator (refer to
ment process quicker and easier, we recommend
using a rotacator (refer to
Page 28) to gauge
the bed roller height from the table surface. if a
rotacator is not available, a straightedge and feel-
er gauges can be used, but care must be taken to
achieve accurate results.
rotacator is not available, a straightedge and feel-
er gauges can be used, but care must be taken to
achieve accurate results.
Roller
Table
0.002"–0.020"
figure 18. recommended bed roller height
above the table surface.
Depth of cut
the planing depth of cut is controlled by using
the table height handwheel on the right side of
the machine. rotating the handwheel clockwise
raises the table.
the table height handwheel on the right side of
the machine. rotating the handwheel clockwise
raises the table.
the depth of cut is read directly from the inch/mil-
limeter scale on the front of the planer, as shown
in
limeter scale on the front of the planer, as shown
in
figure 17.
one complete turn of the handwheel raises or
lowers the table approximately
lowers the table approximately
1
⁄
16
". the range of
material thickness that can be planed is
3
⁄
16
"–8".
figure 17. depth of cut indicator and scale.
depth of Cut
indicator &
scale
table
height
handwheel
the depth of cut on a planer means the amount
of material that is removed from the top of
the workpiece as it passes underneath the
cutterhead.
of material that is removed from the top of
the workpiece as it passes underneath the
cutterhead.
the depth of cut is set by adjusting the distance
of the table below the cutterhead. this distance
is the thickness of the workpiece minus the depth
of cut.
of the table below the cutterhead. this distance
is the thickness of the workpiece minus the depth
of cut.
Although the correct depth of cut varies accord-
ing to wood hardness and workpiece width, we
recommend a maximum depth of cut no more
than
ing to wood hardness and workpiece width, we
recommend a maximum depth of cut no more
than
1
⁄
16
”. A series of light cuts will give better end
results and put less stress on the planer than try-
ing to take off too much material in a single pass.
ing to take off too much material in a single pass.