Ridgid R350RHA Manuale Utente

16

17

Fig. 12

Disconnect  the  tool  from  the  air  supply  before 
removing  nails  or  clearing  a  jammed  fastener. 
Failure to do so could result in serious personal 
injury.

See Figure 12.
n 

Disconnect the tool from the air supply.

n 

�To remove a strip of nails from the tool, press the release 
button on the pusher. When released, the pusher will slide 
forward.

 

NOTE: Always keep fingers clear of nail track of magazine 
to prevent injury from unintended release of the pusher.

n 

Press  down  on  the  nail  stop  tab  near  the  end  of  the 
magazine and slide the nails over the tab.

n 

Remove the nail strip from the tool.

See Figure 13.
If a nail or fastener becomes jammed in the tool, disconnect 
the air hose and keep the tool pointed away from you while 
clearing the jam.
n 

Disconnect the tool from the air supply.

n 

�Remove fasteners from the tool.

n 

Insert a #2 Phillips screwdriver into the driving mecha-
nism. 

n 

Tap the screwdriver gently with a hammer. The  inserted 
screwdriver should push the driver blade back, freeing 
the nail jam.

n 

Remove the bent nail, using needle-nose pliers if neces-
sary.

n 

Reconnect the tool to the air supply.

n 

Reload the tool with nails.

Fig. 13