Roland VC-1 D-50 Manuale Utente
11
Try Out the Sounds
To prevent malfunction and/or damage to speakers or other devices, always turn down the volume, and
turn off the power on all devices before making any connections.
turn off the power on all devices before making any connections.
fig.03-01e(ConnectionImage)
1.
Before hooking anything up, make sure that the power on all of your gear is
turned OFF.
turned OFF.
2.
Connect the V-Synth XT to your amp/speaker system.
3.
Turn on the V-Synth XT’s Power switch.
4.
Turn on the power for any connected amplifiers or speakers.
5.
After the V-Synth XT has started up, press the [V-CARD] button and touch “D-
50” (VC-1) in the screen that appears. The VC-1 Startup screen appears.
50” (VC-1) in the screen that appears. The VC-1 Startup screen appears.
*
When you turn on the power, the V-Card that was most recently started will start up.
6.
Wait for the VC-1 to start up. When it has started up normally, a screen like the following will appear. The
display shows the selected Patch.
display shows the selected Patch.
fig.03-02e(Card&LCD_default)
Turning On the Power
Monitor Speakers
Power amp
Mixer, etc.
Patch number
Key mode
Split point
The volume balance of the Upper & Lower Tone
Patch name
Tone name
vc1_for_XT_e1 11 ページ ２００５年３月８日 火曜日 午後１２時５５分