Invacare IRC5P Manuale Utente
SECTION 7—COMPRESSOR
35
CAUTION
DO NOT lubricate or use oil on any moving parts. The compressor eccentric uses a
precision sealed bearing. Therefore, additional lubrication is not necessary.
precision sealed bearing. Therefore, additional lubrication is not necessary.
Removing Compressor and Compressor Heads
Compressor
1. Unplug concentrator and carefully remove compressor from concentrator. Refer to
Compressor Head Plate
NOTE: For this procedure, refer to FIGURE 7.3.
NOTE: For this procedure, refer to FIGURE 7.3.
1. Clean loose dirt from the outside of the
compressor.
2. Use the Torx T‐25 torque wrench and
loosen the eight head screws.
3. Note head placement before removing
compressor head plate.
4. Remove the compressor head plate.
Valve Plates
NOTE: For this procedure, refer to FIGURE 7.3.
NOTE: For this procedure, refer to FIGURE 7.3.
1. Note the position of the plates before
removing.
2. Lift off the valve plate on one side.
3. Repeat for the other side.
NOTE: Note the position of the tab on valve
plate for reassembly.
plate for reassembly.
NOTE: To avoid confusion, ONLY service one
end of the compressor at a time.
end of the compressor at a time.
FIGURE 7.3 Removing Compressor and
Head Plate - Valve Plates
Head
Screws
Head Screws
Compressor
Head
Plate
Valve
Plate
Valve
Plate
Compressor