Grizzly G7873 Manuale Utente

Pagina di 32
Model g4181/g7873 1-hp power Feeder
-15-
position  the  power  feeder  on  the  table  top  to 
determine  where  to  drill  your  base  mounting 
holes, so you can maximize power feeder swing 
and adjustment options. 
there  are  two  mounting  options  available: 
Through  Bolt  Mounting  and  Direct  Mounting 
(discussed  on 
Page  16).  Choose  an  option  that 
suits your requirements.
Whichever  way  you  mount  your  power  feeder, 
you must be able to use the handcranks and lock 
levers to position the rubber wheels parallel with 
the table surface and 
1
8
" lower than the thickness 
of your workpiece. 
also, you must be able to point the power feeder 
slightly towards the machine fence (
Figure 8). in 
other words, the tracking of the power feeder must 
be toed-in approximately 1° to 1.5° degrees toward 
the  machine  fence  so  the  rubber  wheels  slightly  
push the workpiece against the fence during cut-
ting operations.
;ZZY
;ZZY
Tablesaw
Shaper
8jiiZg
;ZZY
Jointer
8jiiZg]ZVY
7aVYZ
;ZcXZ
;ZcXZ
;ZcXZ
)i]"GdaaZg
BdYZah
Figure 8. typical power feed mounting on a shaper, jointer, and tablesaw.
base Mounting