Chauvet Work Light Manuale Utente
5. Appendix
7
5/7/2010 1:21 PM
3.
S
ETUP
AC Power
This fixture runs on 100~240 VAC, 50/60 Hz. Before powering on the unit, make sure the line voltage
to which you are connecting it is within the range of accepted voltages.
to which you are connecting it is within the range of accepted voltages.
Always connect the fixture to a switched circuit. Never connect the fixture to a rheostat
(variable resistor) or dimmer circuit, even if the rheostat or dimmer channel is used only as a 0
to 100% switch.
(variable resistor) or dimmer circuit, even if the rheostat or dimmer channel is used only as a 0
to 100% switch.
To determine the power requirements for a particular fixture, see the label affixed to the back plate of
the fixture or refer to the f
the fixture or refer to the f
ixture’s specifications chart. A fixture’s listed current rating indicates its
average current draw under normal conditions.
Always connect the fixture to a circuit with a suitable electrical ground.
Fuse Replacement
1.
With a Philips #2 screwdriver unscrew the fuse holder out of its housing.
2.
Remove the damaged fuse from its holder and replace with exact same type fuse.
3.
Insert the fuse holder back in its place and reconnect power.
See the “Technical Specifications” section for the fuse size.
Disconnect the power cord before replacing a fuse and always
replace with the same type fuse.
replace with the same type fuse.
The fuse is
located here