AEG F89078VI-M Manuale Utente
22
Rev 0.0
INSTALLATION INSTRUCTIONS
EN
Connecting to a waste disposal unit with an air gap
MAKE THE CONNECTION UPLINE FROM THE SIPHON OF THE DRAIN
LINE AND AT LEAST 400 mm (15-3/4”) ABOVE THE FLOOR ON WHICH
THE DISHWASHER WILL BE INSTALLED.
LINE AND AT LEAST 400 mm (15-3/4”) ABOVE THE FLOOR ON WHICH
THE DISHWASHER WILL BE INSTALLED.
Remove the cover of the waste disposal unit (ref. A fi g. 5-12).
1.
Connect the dishwasher drain hose (ref. B fi g. 5-12) to the air gap (ref. C fi g.
2.
5-12) using the wide spring clamp (ref. D fi g. 5-12); if necessary, cut the end of
the dishwasher drain hose (ref. E fi g. 5-12) (do not cut the corrugated section).
If the drain hose has been cut, use a 38 to 50 mm (1-1/2 to 2”) screw clamp*.
To connect the air gap (ref. C fi g. 5-12) to the waste disposal unit inlet (ref. F fi g.
the dishwasher drain hose (ref. E fi g. 5-12) (do not cut the corrugated section).
If the drain hose has been cut, use a 38 to 50 mm (1-1/2 to 2”) screw clamp*.
To connect the air gap (ref. C fi g. 5-12) to the waste disposal unit inlet (ref. F fi g.
3.
5-12), use a rubber union* (ref. G fi g. 5-12) with spring or screw clamps* (ref. H
fi g. 5-12).
fi g. 5-12).
* Available from any plumbing stockist
Fig. 5-12
C
D
B
G
H
H
A
E