DeLonghi TRD4 Manuale Utente

5

Reminder
To completely shut the appliance off, turn the power selector to 
the "0" position and then unplug the appliance from the outlet.

To program heating, proceed as follows:
-  Look at the time on your clock or watch. If it is 10 p.m., turn 

the numbered timer disk clockwise until the number 22 (10 
p.m.) on the disk coincides with the pointer s  (3) on the 
timer. Set the periods of time when you want the appliance 
to work by pushing the teeth (1) inward. Each tooth (1) 
corresponds to a period of 15 minutes. This will leave 
visible sectors which correspond to the periods of operation 
(2). When set, the radiator will operate automatically each 
day during the times programmed (important: the radiator 
must always be plugged into the socket).

-   To change the programming, move the teeth back into the 

initial position and set the new periods of operation.

-   To turn the appliance off completely, as well as turning the 

knob to the off position, you must also unplug it from the 
power outlet to avoid continued operation of the timer.

The timer is like an electric clock, and will only work when 
plugged into a power supply. When unplugged, the timer stops 
and must be later re-set.

Timer override
If you wish to override the timer settings, push the timer switch 
to position I (fig.2) manual (timer override). To return to timed 
operation push the switch back to the middle position  

  

(fig.2).

Heater off

Timer operation

Manual (timer override)

Safety device
A safety device shuts the radiator down in the case of 
overheating. To start the radiator up again, contact Customer 
Experience. See enclosed guarantee leaflet.

Always unplug the heater from the power outlet and allow the 
radiator to cool. Wipe radiator with a soft damp cloth; do not 
use detergents or abrasives. Should the radiator not be in use 
over a certain length of time, wind the cord around the holder 
and store it in a dry place. This appliance has been built to last 
for many years of trouble-free service. In case of malfunction 
or doubt, do not try to repair the heater by yourself: this might 
increase the risk of fire and electric shock. Please refer to the 
enclosed guarantee leaflet for service and assistance details.

The appliance doesn't work

Be sure it is plugged in and that the 

electrical outlet is working.
Check for any obstruction.

The temperature may be set too low.

Plug into the power outlet.

Remove the obstruction and let the 

appliance cool down. If the appliance 

doesn't work please contact Customer 

Experience.
Set the temperature to a higher position.

Fig. 2