Mitsubishi Electronics 882.00207.00 Manuale Utente
882.00207.00
Chapter 7: Appendix
91 of 102
Alarm Setup
This screen allows the user to configure the feeder type for each feeder; configure whether a feeder
will retry during the metering of a batch, and enable or disable the “Out of Material” alarm for any
feeder. If a hopper is set to “No Retry” then the blender will continue to meter the rest of the batch
even if this hopper runs out of material. No “Out of Material” alarm will be given regardless of how
the alarm is configured unless the user has purchased and wired in the low level proximity switches
in each hopper. To configure each hopper, perform the following steps:
will retry during the metering of a batch, and enable or disable the “Out of Material” alarm for any
feeder. If a hopper is set to “No Retry” then the blender will continue to meter the rest of the batch
even if this hopper runs out of material. No “Out of Material” alarm will be given regardless of how
the alarm is configured unless the user has purchased and wired in the low level proximity switches
in each hopper. To configure each hopper, perform the following steps:
1. Select a feeder by touching the “Select Feeder” box.
2. The current settings for that hopper will be shown.
3. Make the necessary adjustments and select a new feeder to configure if desired.
4. Press “Done” to exit.
Typical Alarm Flags & Feeder Setup Screen
Alarm Log
This screen shows the last 100 stored alarms. The log can be viewed, printed and cleared.
Typical
Alarm
Log
Screen
Clear Alarm
Log
Log
Print Alarm
Log
Log
Alarm Log
Go back to
Setup
Directory
Setup
Directory
Scroll Through
Alarm Log
Alarm Log
Select a Feeder to
Configure
Configure
Change the Alarm
Silence Delay
Silence Delay
Enable or Disable
Retries
Retries
Enable or Disable
Alarms
Alarms
Go back to Setup
Directory
Directory