Smeg LSPX1253 Manuale Utente

 

 

STARTING THE DISHWASHER 
After carrying out all the operations described above correctly, to start 
the dishwasher simply press the press the START/PAUSE button (4) for 
a few seconds until a beep sounds (the PROGRAM STARTED (5) light 
starts to flash). The 3-FIGURE DISPLAY (12) will show the duration of 
the program in minutes. The duration time is only approximate, because 
it depends on the washing conditions (quantity of dishes, water 
temperature, etc.), and is also continually updated as the washing 
program progresses. 

 
 

 

 

 

 

 

 

 

If it is necessary to open dishwasher door during the washing cycle, 
there will be a 1-minute delay before the program can be resumed. 
After correctly closing the door, press the START/PAUSE  (4) button 
again. This operation may negatively affective the progress of the 
washing cycle. 

 
 
 

 

END PROGRAM 
The end of the program is indicated by a short signal acoustic and from 
the “End” visual notification on 3-FIGURE DISPLAY (12). By pressing 
the  PROGRAM SELECTION button (2), the “End” visual signal will 
vanish from the display and the dishwasher is ready to continue a new 
cycle, the same thing happens when closing or opening the door or by 
switching on-off the machine. 

 
 
 

 

REMOVING THE DISHES 
At the end of the washing program, wait at least 20 minutes before 
removing the dishes, to allow them to cool down. To prevent any water 
droplets on the upper basket from falling on the dishes in the lower 
basket, it is advisable  to unload the lower basket first, and then the 
upper basket.