Smeg DF410BL1 Manuale Utente

Pagina di 32
 
 
 
User instructions 
 
 
 
13 
 
 
 
 
 
TO CHANGE A PROGRAM 
To change the running program it is necessary: 
 
• 
to interrupt the running program (see “I
NTERRUPTING A PROGRAM
”); 
• 
select the new program; 
•  to press again the START/STOP button (5) to make start the new 
program. 
 
 
 
 
 
 
STOPPING A PROGRAM 
To stop a program in progress, it must first be interrupted (see 
"I
NTERRUPTING A PROGRAM
"). 
 
 
 
 
 
Now press buttons P1+P2 simultaneously and 
the first three program lights will come on.
 
 
 
The display will show "P0" and the dishwasher will immediately switch to 
the end of the cycle and drain the tank (during this process, the "Time to 
end
" message will flash). When the drain procedure ends, the end of 
cycle message "End" appears on the display.
 
 
 
 
 
 
In case that the door is opened during the operation, to the next door 
closing it is going to be necessary to start the program as shown in 
paragraph “S
TART PROGRAM
”. The  program will resume from the point in 
which it was interrupted. 
In case that the tub temperature is higher than 50°C the program 
will start about 30 seconds later. 
 
 
 
 
The washing cycle will not take place if the dishwasher door is left open or 
not properly closed.