Anetsberger Brothers 14GS 14GU Manuale Utente

4

Figure 1.  Fryer Model 14GS  Wiring Diagram

Figure 1 is a wiring diagram of an
ANETS

14GS Fryer.  Some fryers

may have other options that do not
appear in this basic wiring diagram.  A
model-specific wiring diagram  included
with each fryer shows all the actual parts
and their associated wiring connections.
In addition, a fryer equipped with a built-
in filter sys- tem (Filtronic II or Filter
Mate) has a supplementary manual
included for that option.

FRYER ELECTRICAL SPECIFICATIONS

ANETS

FRYER GAS SUPPLY SPECIFICATIONS

Please make sure that your desired fryer location has gas

supply factors that are suitable for this product:

Natural Gas

Propane

3½

“

  W.C. 

10

“

  W.C.

6

“

  W.C., minimum

11

“

  W.C., minimum

INPUT REQUIRED:

SUPPLY PRESSURE

MANIFOLD PRESSURE

     BTU/Hr Rating is based on sea level operation.  For sites above 2000 feet, reduce this

       rating 4% for each 1000 feet above sea level.

  

   “

W.C. = Inches, Water Column.

           Measure Supply Pressure when all other gas-powered equipment is operating.

Gas Supply Inlet Pipe size must be ¾“   NPT
(National Pipe Thread) standard gas line.  The gas
supply inlet line should be as straight as possible
(fewest bends or elbows) to obtain the highest
available gas pressure at the fryer.  Locate this
inlet line horizontally at the center of the desired
fryer location, 8¼“   above the floor.

  Using a flexible inlet line permits variation

in the gas supply line location, both horizontally and
vertically.

Anets fryers are only for use with the type of gas
specified on the spec plate.  if a fryer requires
modification to use a gas other than that which is
identified on the fryer spec plate, contact you Anets
representative or call (800) 837-2638.