Amana 12631105 Manuale Utente

Pagina di 48
Installation instructions
REMOVE PACKING 
MATERIALS: 
Remove materials, tape and labels 
before using the freezer. 
Do not use sharp instruments, rubbing 
alcohol, flammable fluids or abrasive 
cleaners. These can damage the 
material. 
Clean your freezer before using it: 
1. Use a sponge, cloth or paper towel 
and mild detergent in warm water to 
clean outside and inside of freezer, 
door liner and gasket. 
2.  Rinse and dry thoroughly. 
CHOOSE FREEZER 
LOCATION: 
1. Locate the freezer in a safe place, 
indoors, away from direct sunlight or 
heat sources such as a range, dish-
washer, laundry equipment, heat 
vents or radiator. 
2. DO NOT store flammables such as 
gasoline near the freezer. 
3. Check the strength of the floor. It 
should hold the weight of a fully 
loaded freezer. 
4.  Allow at least 3" (7.5 cm) between top 
of freezer and the ceiling. 
5. Allow at least 1" (2.5 cm) between 
back of freezer and the wall. 
6.  Allow 3" (7.5 cm) on each side of the 
freezer for ease of installation. 
7. If the freezer is to be against a wall, 
you might want to leave extra space 
on the hinge side so the door can be 
opened wider. 
8.  This freezer is designed to operate at 
a household temperature of 32° to 
110° F (0° to 43° C). 
INSTALL FREEZER:
Raise 
Lower 
1.  Locate the 2 front levelling legs among 
the packing materials. 
2. Screw these legs into the front holes 
on the bottom of the freezer. The back 
of the freezer rests on 2 fixed sup-
ports. 
3.  Adjust the 2 front legs so that the front 
of the freezer is slightly higher than the 
back. When adjusted properly, the 
door will swing shut from 10" open.