Defy Appliances DCH285 Manuale Utente
Page 3
Preparing for installation.
The extractor hood has the ability to ei-
ther recirculate the filtered air back into
the kitchen, or to vent the filtered air
through an outside wall.
Decide on which option best suits you be-
fore commencing with the installation.
ther recirculate the filtered air back into
the kitchen, or to vent the filtered air
through an outside wall.
Decide on which option best suits you be-
fore commencing with the installation.
•
The extractor hood is intended to be
mounted onto a flat perpendicular kitchen
wall capable of supporting the weight of
the hood. (approximately 16 to 26 kg de-
pending on the model).
mounted onto a flat perpendicular kitchen
wall capable of supporting the weight of
the hood. (approximately 16 to 26 kg de-
pending on the model).
Tools required for installation:
•
An electric drill.
•
A 3.5 mm diam. steel drill bit.
•
8mm and 5mm diam. masonry drill bits
•
A star screw driver (Posi 2).
•
A ratchet with a 10mm socket and a
100mm extension.
100mm extension.
•
A tape measure, masking tape and a pen-
cil.
cil.
Venting air to the outside.
When discharging the air into a ventila-
tion shaft or directly through the wall
into the open , please take note of the fol-
lowing:
tion shaft or directly through the wall
into the open , please take note of the fol-
lowing:
• Exhaust air from the extractor hood
must not be directed into a flue or
chimney which is used for exhausting
the fumes or smoke from other appli-
ances burning gas or fuels.
chimney which is used for exhausting
the fumes or smoke from other appli-
ances burning gas or fuels.
• Please ensure that regulations concern-
ing the discharge of exhaust air have
been fulfilled. (SABS IEC 60335-2-31).
been fulfilled. (SABS IEC 60335-2-31).
For optimum extractor hood efficiency use
a short, smooth, round air exhaust pipe with
as few bends as possible A 150mm diameter
exhaust pipe is recommended. Long box
section, narrowed or bent pipes will hinder
performance and increase noise levels.
• Connecting a 150 mm diameter pipe:
Mount the pipe directly onto the air outlet
on the extractor hood.
on the extractor hood.
• Connecting a 125 mm or 100mm di-
ameter pipe: Attach a reducing connec-
tor (available from a specialist retailer)
to the air pipe and then attach to the ex-
haust-air duct.
tor (available from a specialist retailer)
to the air pipe and then attach to the ex-
haust-air duct.
DESCRIPTION
ITEM
QUANTITY
8mm wall plug
6mm screw
5mm wall plug
5mm screw
6mm screw
5mm wall plug
5mm screw
Self tapping screw
Slotted washer
4
6
10
4
Care must be taken during installation not
to obstruct these vents.
No ducting is required for this type of in-
stallation.
to obstruct these vents.
No ducting is required for this type of in-
stallation.
The extractor hood filters out solid particles
before the air is recirculated, via the vents
on the side of the upper chimney, into the
kitchen.
before the air is recirculated, via the vents
on the side of the upper chimney, into the
kitchen.
Recirculating filtered air.
Recirculate
filtered air
Exhaust air through a dedicted pipe
not shared with another fuel burning appliance.
ceiling
ceiling
ceiling