Thecus 2.5TB Network Storage N5200BPRO_5050 Dépliant
Codici prodotto
N5200BPRO_5050
45
LAN Configuration
The N5200PRO supports two Gigabit
Ethernet ports for higher service availability.
To configure these ports, choose LAN from
the Network menu, and the LAN
To configure these ports, choose LAN from
the Network menu, and the LAN
Configuration screen appears. Press Apply
to save your changes.
to save your changes.
LAN Configuration
Item Description
MAC Address
MAC Address
Displays the MAC address of the LAN interface.
IP
Specifies the IP address of the LAN interface.
Netmask
Specifies the Network Mask of the LAN interface.
Jumbo Frame Support
Enable or disable Jumbo Frame Support on the LAN interface.
DHCP Configuration
A DHCP server can be configured to assign IP addresses to devices connected to
the LAN port. To configure these ports, choose LAN from the Network menu.
DHCP Configuration
Item Description
DHCP Server
DHCP Server
Enable or disable the DHCP server to automatically assign IP
address to PCs connected to the LAN interface.
Start IP
Specifies the starting IP address of the DHCP range.
End IP
Specifies the ending IP address of the DHCP range.
DNS Server
Displayed the DNS server IP address.
WARNING
Most Fast Ethernet (10/100) Switches/Routers do not support Jumbo
Frame and you will not be able to connect to your N5200PRO after
Jumbo Frame is turned on. If this happens, turn off the N5200PRO.
Then, power on the N5200PRO and immediately press and hold the
Reset button on the back of the unit for 10 seconds. This will reset
your network settings, password, and turn off Jumbo Frame Support.
NOTE
Before enabling Jumbo Frame Support, please make sure your network
equipment supports Jumbo Frame. If your equipment is incompatible,
you might not be able to connect to your N5200PRO. In this case, you
have to reset the system back to default by the holding down front
panel reset button for 5 seconds during boot up process.
NOTE
The IP Segment of WAN and LAN should not overlap.
WARNING
The IP address of the LAN interface should not be in the range of the
Start IP address and End IP address.