Seagate ST31230DC Manuale Utente
continued from previous page
SS
Off On
Off On
Reserved. Default is no jumper installed.
TP TP
(Not applicable to "WC/DC" model drives)
Off Off
No terminator power is connected to drive
terminators or SCSI bus I/O pin 26.
terminators or SCSI bus I/O pin 26.
On Off
Drive supplies its own terminator power only.
Jumper on this position is factory default.
Jumper on this position is factory default.
Off On
Drive supplies power to I/O pin 26 of SCSI
bus; none to internal terminators. When
drives have differential I/O circuits a jumper
on the right TP position may be needed to
power external terminator (see system docu-
mentation). The "WD" drive has differential
I/O circuits which have no terminator circuits
on the drive. The "WC/DC" Model drives
have no provisions for terminators on the
drive and no provisions for terminator power
on the 80 pin I/O connector.
bus; none to internal terminators. When
drives have differential I/O circuits a jumper
on the right TP position may be needed to
power external terminator (see system docu-
mentation). The "WD" drive has differential
I/O circuits which have no terminator circuits
on the drive. The "WC/DC" Model drives
have no provisions for terminators on the
drive and no provisions for terminator power
on the 80 pin I/O connector.
On On
Drive supplies terminator power to itself (in-
ternal connection) and to I/O pin 26 of SCSI
bus. This is a legal jumper setting.
ternal connection) and to I/O pin 26 of SCSI
bus. This is a legal jumper setting.
Off
See above explanations for TP jumpers.
TP Position A
On
On
This horizontally positioned jumper across
the two TP positions nearest PCB edge,
connects terminator power from SCSI bus
the two TP positions nearest PCB edge,
connects terminator power from SCSI bus
30 Hawk 2LP (Wide) Installation Guide, Rev. A