U-Line CLR2160 STAINLESS Manuale Utente

Pagina di 20
8
U-Line Ice Maker
Cle
Clear Ice Maker Cleaning Cycle
Interval - Every 3 Months
To maintain operational efficiency, clean the unit every three 
months (depending on water conditions, more or less frequent 
cleaning may be necessary). If the ice maker requires more 
frequent cleaning, consult a qualified plumber to test the water 
quality and recommend appropriate treatment.
IMPORTANT
IMPORTANT
Wear rubber gloves and safety goggles and/or face shield 
when handling Ice Machine Cleaner.
CAUTION
Use only U-Line Ice Machine Cleaner (Part No. 41978, 
available from your dealer or direct from your local parts 
distributor. To locate a parts distributor near you, visit 
www.U-LineService.com. It is a violation of federal law to 
use this solution in a manner inconsistent with its labeling. 
Use of any other cleaner can ruin the finish of the 
evaporator and will void the warranty. Read and 
understand all labels printed on the package before use.
U-Line Ice Machine Cleaner is used to remove lime scale and other 
mineral deposits. Refer to the following steps to initiate the self-
cleaning cycle.
IMPORTANT
IMPORTANT
• Model CLRCO2175 refrigerator will not operate during 
the ice maker cleaning cycle. Remove all fresh food to 
prevent spoilage.
• Model CLRCO2175 ice production after the first 
harvest may take longer after the cleaning cycle since 
restoring the refrigerator temperature will take 
precedence over ice production. Once the refrigerator 
reaches its set-point temperature, ice making will 
resume.
CAUTION
Never use anything to force ice from the evaporator. 
Damage may result.
1. Turn the ice maker 
off (allowing any ice 
to melt off of the 
evaporator) as 
follows:
2. Remove all ice from 
the storage bin.
3. Remove evaporator 
cover (Figure 21).
4. Remove the standpipe by lifting it up while using a slight back and 
forth motion to loosen it from the drain hole. The water in the 
reservoir will flow down the drain. 
5. Re-install the standpipe into the water trough.
6. Clean the Interior Bin as follows:
• Dilute one packet of CLR cleaner into two quarts of water.
• Using a sponge or cloth, clean interior of ice bin, tubing and 
door. This cleaner will remove all mineral deposits and 
other contaminants from the surfaces.
• Using a bottle brush, clean out the trough drain tube and 
pump tubing where needed.
7. Place the unit into CLEAN mode by pressing and holding the 
POWER button for 10 seconds while pressing the LIGHT 
button three times.
8. When water begins flowing over the evaporator (approximately 
3 minutes), pour 1 packet of CLR cleaner into the water trough. 
The cleaning process will last approximately 45 minutes.
9. Following the cleaning process, sanitize the ice bin with a dilute 
bleach solution. (1 Tablespoon bleach per gallon of water).
Dilute 1 tablespoon bleach in 1 gallon of warm water. Apply this 
solution to the entire inside of the storage area. Then rinse 
thoroughly with water.
5 Clear Ice Maker 
Evaporator cover
Standpipe
Evaporator
Water trough
Brush