U-Line U-2175RCB-00 Manuale Utente

u-line.com

11

13. Use a level to check 

the levelness of the 
unit from front to 
back and from side 
to side. Level should 
be placed along top 
edge and side edge 
as shown. 

14. If the unit is not level, adjust the feet on the corners of the unit 

as necessary (not available in CO29 models).

15. Check the levelness after each adjustment and repeat the 

previous steps until the unit is level.

If the room floor is higher than the floor in the cut-out opening, 
adjust the rear feet to achieve a total unit rear height of 1/8" less 
than the opening’s rear height. Shorten the unit height in the front 
by adjusting the front feet. This allows the unit to be gently tipped 
into the opening. Readjust the front feet to level the unit after it is 
correctly positioned in the opening.

1

Turn Foot to Adjust

1. Plug in the powercord.

2. Gently push the unit into position. Be careful not to kink the 

water supply line or entangle the electrical cord.

3. Re-check the leveling, from front to back and side to side. Make 

any necessary adjustments. The unit’s top surface should be 
approximately 1/8" below the countertop.

4. Remove the tape from the glass shelves and wipe out the inside 

of the unit with a clean, water-dampened cloth.

Both the glass shelves in the refrigerator and the inner door 
shelves can be moved to accommodate your bottles, cans and 
containers.

• Open door fully, grasp shelf firmly, lift front edge slightly, and 

pull straight out.

• Choose new location and slide shelf onto the appropriate rib.

• Pull shelf out about 6" to clear the wall’s molded protrusion.
• Tilt right-hand edge of shelf up.
• Keeping at this angle and hugging the right wall, pull the shelf 

out.

• Choose new location and insert over ribs, tilting right-hand 

edge up. Push in, then lower shelf onto ribs.

• First pull shelf up at a 45° angle, then straight out.
• Choose new location and line up on bosses. First push straight 

in, then down at a 45° angle.

The door remains open unless it is pushed closed.

The hinges should be self-closing when the door is open 
approximately 8". If this is not the case, make sure the closers are 
clean, greased and installed correctly. Also, re-check leveling from 
front to back of the unit and readjust if necessary. Make sure that 
pivot plate is installed correctly.

The custom overlay door was designed to align with the rest of the 
cabinet doors, but the unit has crept forward.

Make sure that the electrical cord and water supply line are not 
obstructing the installation.