Sony KDL-55W829B/50W829B KDL-55W828B/50W828B Manuale Utente

 then press the touchpad.)

You can adjust the following 3D settings.
Press the HOME button, select   [Settings] →   [Display] → [3D Settings] → the desired

 option.

Opens [3D Display] to switch the display modes.

Adjusts the depth of 3D pictures on the screen (available only for content with 3D signals). You can

 manually set the adjustment value.

Heightens/lessens the 3D effect when you display 2D pictures in simulated 3D.

Sets the image brightness when using the 3D display mode. By selecting [Auto], image brightness

 through the Active 3D Glasses is automatically adjusted in conjunction with the [Picture Mode]

 setting.

Select [Auto 1] to switch the 3D display mode automatically when a 3D signal is detected.

 If no 3D signal is detected, select [Auto 2], which will analyse the image for 3D information and

 switch the 3D display mode automatically.

 Select [Off] to prevent the 3D display mode from being automatically selected. 

Depending on the input signal or format, the 3D display mode may not switch automatically.

 In such a case, press the 3D button to select the 3D display mode manually. 

(When using the Touchpad Remote Control, press the Control Bar (

), slide the touchpad to

 highlight the 3D button, then press the touchpad to select.)

Notifies when a 3D signal is detected.

If the LED indicates low battery power (indicator blinks green 3 times every 2 seconds), replace

 the battery. Use a CR2025 battery only. Press the unlock button with the tip of a pen, etc, and

 take out the battery case, then replace the battery with a new one. After that, be sure to lock the

 battery case again.

If you wear glasses, remove the nose pad from the Active 3D Glasses by pulling it down, then wear
 them over your glasses.

3D effect is available only when pictures are displayed in full screen.
 If [Motionflow] is set to other than [Off], the smooth movement of the picture may be lost as the
 picture process to minimise screen flicker is applied. In such a case, set [Motionflow] to [Off] to
 display the original picture.

58