Sceptre Technologies X20g-NagaIII Manuale Utente

Change to one of the alternate modes listed in Appendix B, or 
replace the VGA card and repeat steps 1 and 2. 

If the power LED is not lit, check that the AC power connector is 
securely connected, and verify that the AC adapter LED is lit.  If 
the AC adapter LED is not lit, please contact your dealer for 
assistance.

 

 

If you have a CRT monitor, please connect the CRT monitor to 
the computer and change the refresh rate down to 60hz via 
your video card’s display settings menu.  After the setting of 
60hz has been change you can then use the LCD on the 
computer.

 

If you do NOT have a CRT monitor, please make sure both the 
X20G-NAGAIII and your computer is turned off.  Afterwards 
turn on the LCD and the computer.

 

While the computer is turned on, press the “F8” key on your 
keyboard continuously until a selection menu appears and 
select the “Safe Mode” option.

 

When you’ve entered Safe Mode please uninstall any video 
card driver and monitor driver by using either the “Add / 
Remove Programs” icon or going into “System Properties” and 
manually removing anything under “Monitors” and “Display 
Adapters”.

 

After removing all the drivers, please reboot your computer and 
you should be able to see windows.  Please then procede to 
install your monitor driver first, then your video card driver.  
Please remember to make sure your refresh rate should be at 
60hz.