Maytag MFI2067AES Manuale Utente

If you need to clean the condenser:

■

Remove the base grille.

■

Use a vacuum cleaner with a soft brush to clean the grille, 
the open areas behind the grille and the front surface area 
of the condenser.

■

Replace the base grille when finished.

5. Plug in refrigerator or reconnect power.

NOTE: Not all appliance bulbs will fit your refrigerator. Be sure to 
replace the bulb with an appliance bulb of the same size, shape, 
and wattage (no greater than 40 watts). 

1. Unplug refrigerator or disconnect power.

2. Remove the light shield, if necessary.

■

Top of the refrigerator compartment - Squeeze both sides 
of the light shield while pulling downward to remove.

■

Beneath ice storage enclosure (on some models) - Press 
along upper edge of light shield and roll light shield 
forward to remove. 

3. Replace burned-out bulb(s) with appliance light bulb(s) no 

greater than 40 watts.

4. Replace the light shield(s) by inserting the tabs on the shield 

into the liner holes and snap into place.

NOTE: To avoid damaging the light shield, do not force the 
shield beyond the locking point.

5. Plug in refrigerator or reconnect power.

■

Power cord unplugged? Plug into a grounded 3 prong 
outlet.

■

Is outlet working? Plug in a lamp to see if the outlet is 
working.

■

Household fuse blown or circuit breaker tripped? Replace 
the fuse or reset the circuit breaker. If the problem continues, 
call an electrician. 

■

Are controls on? Make sure the refrigerator controls are on. 
See “Using the Control(s).”

■

New installation? Allow 24 hours following installation for the 
refrigerator to cool completely.   

NOTE: Adjusting the temperature controls to coldest setting 
will not cool either compartment more quickly.

Your new refrigerator may run longer than your old one due to its 
high-efficiency compressor and fans. The unit may run even 
longer if the room is warm, a large food load is added, doors are 
opened often, or if the doors have been left open.

Refrigerator noise has been reduced over the years. Due to this 
reduction, you may hear intermittent noises from your new 
refrigerator that you did not notice from your old model. Below 
are listed some normal sounds with explanations.

■

Buzzing - heard when the water valve opens to fill the ice 
maker

■

Pulsating - fans/compressor adjusting to optimize 
performance

■

Hissing/Rattling - flow of refrigerant, movement of water 
lines, or from items placed on top of the refrigerator

■

Sizzling/Gurgling - water dripping on the heater during 
defrost cycle

■

Popping - contraction/expansion of inside walls, especially 
during initial cool-down

■

Water running - may be heard when ice melts during the 
defrost cycle and water runs into the drain pan

■

Creaking/Cracking - occurs as ice is being ejected from the 
ice maker mold.