Maytag MFI2067AES Manuale Utente

Pagina di 58
8
Adjust the Doors
IMPORTANT:
Your refrigerator has two adjustable, front leveling screws – 
one on each side of the refrigerator base. If your refrigerator 
seems unsteady or you want the door to close easier, use the 
instructions below.
Before moving the refrigerator, raise the leveling screws so 
the front rollers are touching the floor. 
1. Remove the base grille. Grasp the grille firmly and pull it 
toward you.
2. Raise or lower the cabinet. 
Using a 
¹⁄₄" hex driver, turn the leveling screw on each side to 
raise or lower that side of the refrigerator.
NOTE: Having someone push against the top of the 
refrigerator takes some weight off the leveling screws. This 
makes it easier to turn the screws. It may take several turns of 
the leveling screw to adjust the tilt of the refrigerator.
To raise, turn the leveling screw clockwise.
To lower, turn the leveling screw counterclockwise. 
3. Open the door again to make sure that it closes as easily as 
you like. If not, tilt the refrigerator slightly more to the rear by 
turning both leveling screws clockwise. It may take several 
more turns, and you should turn both screws the same 
amount.
4. Replace the base grille.
REFRIGERATOR USE
Opening and Closing Doors
There are two refrigerator compartment doors. The doors can be 
opened and closed either separately or together.
There is a vertically-hinged seal on the left refrigerator door.
When the left side door is opened, the hinged seal 
automatically folds inward so that it is out of the way.
When both doors are closed, the hinged seal automatically 
forms a seal between the two doors. 
Using the Controls
The control center is located on the front of the ice and water 
dispenser. 
Temperature Controls
For your convenience, your temperature controls are preset at 
the factory. When you first install your refrigerator, make sure the 
controls are still set to the recommended set points as shown.
Recommended Settings
IMPORTANT: 
When the power is on, the temperature display shows the set 
point temperature of the compartment.
Wait 24 hours for your refrigerator to cool completely before 
adding food. If you add food before the refrigerator has 
cooled completely, your food may spoil.
NOTE: Adjusting the refrigerator and freezer temperature 
controls to a colder than recommended setting will not cool 
the compartments any faster.
A. Leveling screw
A
A. Hinged seal
A