GE JGSP23 Manuale Utente

To adjust your range for use with L.P. gas, follow

these instructions:
1. Disconnect all electrical power at the main

circuit breaker or fuse box.

2. Shut off the gas supply to the range by closing

the manual shut-off valve.

The pressure regulator and the burner orifices are

set for natural gas. To use liquid propane gas, the

regulator and burner orifices must be converted.

The L.P. orifice spuds for the cooktop burners

can be located within a bracket located behind the

storage drawer of this unit.

Do not operate the cooktop or oven

burners of this range when using L.P.

(bottled) gas before converting the

pressure regulator and burner orifices for

L.P. gas use.  Failure to do so could cause

high flames and toxic fumes which can result

in serious injury.

CAUTION:  If you are using L.P. (bottled)

gas, all the adjustments described in the

following steps must be made before you

make any burner adjustments.

a. Remove the storage drawer.
b. Find the pressure regulator by reaching through

the storage compartment and the opening at

the back of the range.

c. Unscrew the cap.
d. Carefully look at the spring retainer to locate the

NAT or LP position.

e. Place your thumb against the flat side of the

spring retainer and press down to remove the

retainer.

f. Turn the spring retainer over so that L.P. is

showing on the bottom.

g. Snap the retainer back into position and

retighten the cap back onto the regulator.